2024 Beneteau America First 18 SE
A wide, flat and stable hull, ballasted swinging keel, gennaker snuffer system, furling jib, and minimized deck controls all facilitate an easy-to-handle yet lively sailing experience. Easily dismantled and trailered, she'll surely fulfill racing ambitions in international one-design classes as well as adventurous sea-camping.
Basic Boat Info
Dimensions
-
Hull and deck constructed with hand layup of Soric and foam sandwich with glass fibres reinforced with polyester and vinyl ester resin
-
Chainplates bolted to the hull
-
Hull reinforced with a stringer and bulkheads of the two insubmersibility chambers
-
Deck with moulded high traction non-skid
-
Two transoms hung rudders built of GRP foam sandwich mounted in custom aluminium cassettes
-
Bolts, screws and fittings made of marine grade stainless steel
-
Hull and deck moulded in single tone off-white
-
Hull sheave in a gel coat finish - prepared for the application of antifouling
-
Cast iron swinging keel with epoxy primer and antifouling protection
-
Stainless steel winch with dyneema high modulus rope for hoisting the keel
-
Safety pin arrangement for fixing the keel in the keel box
-
Slots trip keel lips closing the exit of the keel box
-
Lifting straps attachment point on the top of the keel box
-
Stainless steel chain plates for shrouds and forestay,
-
Semicircular opening hatch on the foredeck for light and ventilation,
-
Ronstan blocks and cleats for the mainsail, jib and gennaker control lines,
-
Ronstan jib track,
-
Composite tiller with Ronstan tiller extension,
-
Soft (neoprene) cover while sailing and hard (plexiglass and GRP) cover for storage and transport
-
Attachments for engine bracket on stern
-
Manual bilge pump operated from the cockpit
-
Carbon fibre mast and boom with local reinforcements
-
Mast protected with UV resistant foil, boom and bowsprit spray- painted with UV clear coat
-
Extending carbon fibre bowsprit
-
On-deck gennaker snuffer system
-
Bartels stainless steel jib furler set
-
U-bolt mooring rings on mid-bow and stern (3 pieces)
-
Custom mast foot which allows for easy setting of the mast without a crane
-
1x19 standing rigging with bottle screw adjusters
-
Outhaul with 2:1 purchase led inside the boom
-
Mainsheet with cleat, swivel, ratchet and four ball-bearing low friction blocks
-
6:1 boom vang purchase
-
Two 2:1 jib sheets with blocks and cleats
-
One 2:1 Dyneema main halyard with cleat
-
One Dyneema jib halyard
-
One masthead gennaker halyard/gennaker retrieving line
-
One bowsprit control line
-
Composite shackles for attachments
-
Two gennaker sheets
-
8:1 Cunningham control line with blocks and cleats